PFlow Industries D116 User Manual

Revision: 3.0.3
FO Frequency Range
Set the highest limit of the output signal frequency.
highest limit frequency values must be greater than
the lower frequency range：1-9999Hz，
Factory default
1~1001Hz.
Note: output frequency signal output from OCT
mouth, so to output frequency signal, must also Be set
OCT into frequency signal output mode （
M78
0. FO).
Low FO Flow Rate
Set up low FO flow rate, i.e. the corresponding flow
value when output signal frequency is at the lowest
FO frequency. For example, when the low FO
frequency is 1000
Hz, low FO flow rate is 100
then when the frequency output is 1000
Hz, the low
flow at
this moment measured by the Flowmeter is
100m3/h.
High FO Flow Rate
Enter the high FO flow rate, i.e. the corresponding
flow value when frequency output signal is at highest
FO frequency. For example, when the low FO
frequency is 5
000Hz, low FO flow rate is
1000m3/h,then when
the frequency output is
the low flow at
this moment measured by the
Flowmeter is 1000m3/h.
LCD Back lit Option
Select LCD back lit controls.
0. Always ON
1. Always OFF
2. Lighting For nn sec
Keep the backlight off can save about 30mA
Working Timer
Display the totalized working hours of the Flowmeter
since last reset. It is displayed by HH:MM:SS. If it is
necessary to reset it, press , and select
"
Menu 6 7
Menu 6 8
Menu 6 9
Menu 7 0
Menu 7 2
Enter
D116
Series Ultrasonic Flowmeter
Set the highest limit of the output signal frequency.
highest limit frequency values must be greater than
Factory default
：
Note: output frequency signal output from OCT
mouth, so to output frequency signal, must also Be set
M78
choose
Set up low FO flow rate, i.e. the corresponding flow
value when output signal frequency is at the lowest
FO frequency. For example, when the low FO
Hz, low FO flow rate is 100
m3/h
Hz, the low
this moment measured by the Flowmeter is
Enter the high FO flow rate, i.e. the corresponding
flow value when frequency output signal is at highest
FO frequency. For example, when the low FO
000Hz, low FO flow rate is
the frequency output is
5000Hz,
this moment measured by the
Keep the backlight off can save about 30mA
power.
Display the totalized working hours of the Flowmeter
since last reset. It is displayed by HH:MM:SS. If it is
"
YES".
FO Frequency Range
1-5000
Low FO Flow Rate [68
0
m3/h
High FO Flow Rate [69
26550
m3/h
LCD Backlit Option
0. Always ON
Working Timer [72
47:16:38
Series Ultrasonic Flowmeter
Page 32 of 53
FO Frequency Range
Low FO Flow Rate [68
m3/h
High FO Flow Rate [69
m3/h
LCD Backlit Option
Working Timer [72

PFlow Industries D116 Specifications

General

Brand	PFlow Industries
Model	D116
Category	Measuring Instruments
Language	English