PFlow Industries D116 User Manual

Revision: 3.0.3
Beeper Setup
Set up the beeper on-off state.
0. ON Beeper ON
1. OFF Beeper OFF
OCT Output Setup
Set OCT output hardware unit
output trigger sources,
selection of triggering events:
0. No Signal 1. Alarm #1
2. Alarm #2 3.
NET Int Pulse
4. Energy Pulse 5. FO
Relay Output Setup
The relay is single-pole and constant-
on for external
instrument controls. The following options are
available:
0. Not Ready (No*R) 1. Alarm #1
2. Alarm #2 3.
NET Int Pulse
Date Totalizer
In this window, it is possible to review the historical
flow data totalizer for any day of
the last 64 days, any
month of the last 64 months and any year
of the
years.
Press , use the or
to review totalizer
in days, months and years. "0" for day, "1"
for month,
"2" for year. Use the or
to review the
totalizer in some day, some month, some year.
For example, to display the flow total for July 18,2000,
the display "-----------"
at the upper right corner of the
screen indicates that it was working properly the
whole day. On the contrary, if "G"
is displa
indicates that the instrument gain was adjusted at least
once. Probably it was offline once on that day. If
is displayed, it indicates that poor signal was detected
at least once. Also, it indicates that the operation was
interrupted or problem
s occurred in the installation.
For more information please refer to "
Error Code and
Resolutions"
Menu 7 7
Menu 7 8
Menu 7 9
Menu 8 2
Enter
^
^
^
^
D116
Series Ultrasonic Flowmeter
output trigger sources,
NET Int Pulse
on for external
instrument controls. The following options are
NET Int Pulse
In this window, it is possible to review the historical
the last 64 days, any
of the
last 5
to review totalizer
for month,
to review the
totalizer in some day, some month, some year.
For example, to display the flow total for July 18,2000,
at the upper right corner of the
screen indicates that it was working properly the
is displa
yed, it
indicates that the instrument gain was adjusted at least
once. Probably it was offline once on that day. If
"H"
is displayed, it indicates that poor signal was detected
at least once. Also, it indicates that the operation was
s occurred in the installation.
Error Code and
BEEPER Setup [77
ON
OCT Output Setup [78
5.FO
RELAY Output Setup
3. NET Int
Pulse
Date Totalizer
0. Day
00 03-04-05
------
>4356.78 m3
Series Ultrasonic Flowmeter
Page 33 of 53
BEEPER Setup [77
OCT Output Setup [78
RELAY Output Setup
Pulse
[82
------

PFlow Industries D116 Specifications

General

Brand	PFlow Industries
Model	D116
Category	Measuring Instruments
Language	English