PFlow Industries D116 - Energy Units Options

Revision: 3.0.3
Automatic Flow Correction
With the function of automatic flow correction, the
flow lost in an offline session can be estimated and
automatically adjusted. The estimate is based on the
average value, which is obtained from flow rate before
going offline and flow measured after going
next time, multiplied times the time period that the
meter was offline. Select "ON" to use
this function
and "OFF" to cancel this function.
Energy Units Options
Select Energy Units. The factory default unit is GJ.
The following options are available:
0. Giga Joule (GJ) 1.
Kilocalorie (Kc
2. MBtu 3. K
ilojoule (
4. Btu 5. KWh
6. MWh
The following units of time are available:
/day ( per day ); /hour ( per hour ); /min ( per
/sec ( per second ). The factory default unit is /hour.
Temperature sensitivity
When the delta temperature is less than the sensitivity
set,, energy will not be accumulated.
adjustable temperature range of 0℃ to 10
℃
The factory default setting is 0.2℃
Energy Totalizer Switch
Select "ON" represent to open Energy Totalizer;
Select "OFF" represent to close Energy Totalizer.
Energy Multiplier
Select Energy Multiplier range: 10
-3
~ 10
4
(E
Reset Energy Totalizer
Select "YES" to reset Energy Totalizer value
Menu 8
3
Menu 8 4
Menu 8 6
Menu 8 7
Menu 8 8
Menu 8 9
D116
Series Ultrasonic Flowmeter
With the function of automatic flow correction, the
flow lost in an offline session can be estimated and
automatically adjusted. The estimate is based on the
average value, which is obtained from flow rate before
online the
next time, multiplied times the time period that the
this function
Select Energy Units. The factory default unit is GJ.
Kilocalorie (Kc
al)
ilojoule (
KJ)
/day ( per day ); /hour ( per hour ); /min ( per
minute );
/sec ( per second ). The factory default unit is /hour.
When the delta temperature is less than the sensitivity
set,, energy will not be accumulated.
Set the
℃
.
Select "ON" represent to open Energy Totalizer;
Select "OFF" represent to close Energy Totalizer.
(E
-3 ~ E4)
Select "YES" to reset Energy Totalizer value
.
Automatic Correction
OFF
Energy Units Select
GJ/h
Temperature Delicacy
0.20 C
Energy Totalizer
ON
Energy Multiplier [88
3. x1
Reset Energy Total
NO
Series Ultrasonic Flowmeter
Page 34 of 53
Automatic Correction
Energy Units Select
Temperature Delicacy
0.20 C
Energy Multiplier [88
Reset Energy Total