NEWVSI TECHNICAL MANUAL – PROGRAMMING PG DRIVES TECHNOLOGY
36 SK80151-1
Acceleration (forward and reverse combined)
Deceleration (forward and reverse combined)
Turn Acceleration (forward and reverse combined)
Turn Deceleration (forward and reverse combined)
Standard PGDT settings are 0 for the minimum fence value and 100 for the maximum fence value, meaning there is a full range
of adjustment. If you wish to apply different fence values, please contact PGDT.
PGDT accepts no liability for losses of any kind if the chair manufacturer does not specify
appropriate safety fence values for a particular scooter application.
1.4 Drive Profiles
The newVSI can operate with single or multiple drive profiles. A drive profile is a collection of programmable parameters
comprising of Acceleration, Deceleration, Turn Acceleration, Turn Deceleration, Forward Speed, Reverse Speed, Turning Speed,
Power, Torque and Tremor Damping. The number of drive profiles is determined by the programmable parameter, Number of
Drive Profiles.
If the value of Number of Drive Profiles is 0, there is one setting for each of the parameters listed previously, and the controller’s
maximum speed setting can be changed with the maximum speed / profile increase and decrease buttons.
If the values of Number of Drive Profiles is 2 to 5, there is a corresponding number of drive profiles and each listed parameter can
be individually set within a profile. The maximum speed /profile increase and decrease buttons are then used to switch between
the available profiles.
Although a number of Drive Profiles can be set to one, the operation is the same as setting to 0
but without the ability to change maximum speed settings.
To Next Page
Loading...