NEWVSI TECHNICAL MANUAL – PROGRAMMING PG DRIVES TECHNOLOGY
38 SK80151-1
3 Speed Parameters
3.1 Acceleration
Adjusts the value for forward and reverse acceleration of the wheelchair.
Adjustable in steps of 1 from 0 to 100.
A higher value gives faster acceleration. This programmed value of acceleration occurs when speed setting 5 is selected. Its
value at other settings depends on the value of the Minimum Acceleration parameter.
3.2 Deceleration
Adjusts the value for forward and reverse deceleration (or braking) of the wheelchair.
Adjustable in steps of 1 from 0 to 100.
A higher value gives faster deceleration. This programmed value of deceleration occurs when speed setting 5 is selected. Its
value at other settings depends on the value of the Min Deceleration parameter.
3.3 Turn Acceleration
Adjusts the value for turning acceleration of the wheelchair, from 0 to 100 in steps of 1. A higher value gives faster acceleration.
This programmed value of acceleration occurs when speed setting 5 is selected. Its value at other settings depends on the value
of the Minimum Turn Acceleration parameter.
3.4 Turn Deceleration
Adjusts the value for turning deceleration (or braking) of the wheelchair.
Adjustable in steps of 1 from 0 to 100.
A higher value gives faster deceleration. This programmed value of deceleration occurs when the controller has speed setting 5
selected. Its value at other settings depends on the value of the Minimum Turn Deceleration parameter.
3.5 Forward Speed
Adjusts the minimum and maximum values for forward speed of the wheelchair.
Adjustable in steps of 1% from 0 to 100%.
A higher value gives a faster speed. The minimum value occurs when speed setting 1 is selected, and the maximum value
occurs at speed setting 5.
3.6 Reverse Speed
Adjusts the minimum and maximum values for reverse speed of the wheelchair.
Adjustable in steps of 1% from 0 to 100%.
A higher value gives a faster speed. The minimum value occurs when the speed setting 1 is selected, and the maximum value
occurs at speed setting 5.
3.7 Turning Speed
Adjusts the minimum and maximum values for the turning speed of the wheelchair.
Adjustable in steps of 1% from 0 to 100%.
A higher value gives a faster speed. If 0 or 1 Drive Profile is selected, then the minimum value occurs when speed setting 1 is
selected, and the maximum value occurs at speed setting 5.
To Next Page
Loading...