NEWVSI TECHNICAL MANUAL – PROGRAMMING PG DRIVES TECHNOLOGY
40 SK80151-1
3.12 Minimum Turn Acceleration
Adjusts the minimum value for turning acceleration of the wheelchair.
Adjustable in increments of 1% of the Turn Acceleration value.
This percentage of the Turn Acceleration value occurs when the newVSI speed setting is at it’s minimum 1 bar illumination.
See following example.
Turn Acceleration = 80 and Minimum Turn Acceleration = 25%
Turn Acceleration at step 1 = 25% of 80 = 20
Speed settings 2, 3 and 4 will interpolate linearly between 20 and 80
Turn Acceleration at step 2 = 35
Turn Acceleration at step 3 = 50
Turn Acceleration at step 4 = 65
3.13 Minimum Turn Deceleration
Adjusts the minimum value for turning deceleration of the wheelchair.
Adjustable in increments of 1% of the Turn Deceleration value.
This percentage of the Turn Deceleration value occurs when the newVSI speed setting is at it’s minimum 1 bar illumination.
See following example.
Turn Deceleration = 80 and Minimum Turn Deceleration = 25%
Turn Deceleration at step 1 = 25% of 80 = 20
Speed settings 2, 3 and 4 will interpolate linearly between 20 and 80
Turn Deceleration at step 2 = 35
Turn Deceleration at step 3 = 50
Turn Deceleration at step 4 = 65
4 Operation Parameters
4.1 Sleep Timer
Sets the period of time after which the controller will go to sleep if the wheelchair is not driven.
The time can be set between 1 and 30 minutes in steps of 1 minute.
If the time is set to 0 the system will never go to sleep.
4.2 Joystick Throw
This allows you to program the controller so that full speed can be reached with a reduced joystick movement (throw). This is
particularly useful for wheelchair users with limited hand or arm movement.
4.2 Invert Joystick
This parameter inverts the direction of travel when moving the joystick.
This parameter can be set to On or Off.
To Next Page
Loading...