Philips 150B6CB/00 - Display Identification; Resolution; Test Conditions; Visual Characteristics

Go to cover page
84
170B6 LCD
20
12
GENERAL PRODUCT SPECIFICATION(Continued)
2) DMPM for Digital signal
According to DDWG standard for DVI rev.1.0
Status DE Video Power LED
On On Active <45W Green /With Audio
On On Active <35W Green /Without Audio
Off Off Blanked <1W Amber
DC Power off N/A <1W Off
3.6 Display identification
3.6.1 In accordance with VESA Display Channel Standard V1.0 and having DDC-2B and DDC/CI
capability.
3.6.2 In accordance with DVI requirement (DDWG digital Visual Interface revision 1.0) use DDC-2B,
DDC/CI, and EDID 3.0 structure 2.0
4.0 Visual characteristics
4.1 Test conditions
Unless otherwise specified, this specification is defined under the following conditions.
(1) Input signal: As defined in 3.3, 1280 x 1024 non-interlaced mode (80K/75Hz), signal
sources must have 75 ohm output impedance.
(2) Luminance setting: controls to be set to 200 nits with full screen 70 % duty cycle white
signal
(3) Warm up: more than 30 minutes after power on with signal supplied.
(4) Ambient light: 400 -- 600 lux.
(5) Ambient temperature: 20 ± 5 °C
4.2 Resolution
Factory preset modes (15 modes)
# Resolution H-Frequency Pixel rate V-Frequency Comment
1 640X350 31.5KHz 25.175 70Hz IBM VGA 10h
2 720X400 31.5KHz 28.322 70Hz IBM VGA 3h
3 640X480 37.5KHz 31.501 75Hz
4 640X480 35.0KHz 30.24 67Hz
5 640X480 31.5KHz 25.175 60Hz
6 800X600 35.2KHz 36 56Hz
7 800X600 46.9KHz 49.498 75Hz
8 800X600 37.9KHz 40 60Hz
9 832X624 49.7KHz 57.28 75Hz MAC
10 1024X768 60.0KHz 78.75 75Hz
BRAND : PHILIPS
17 inch LCD Monitor
TYPE : 170B6CG/00
8639 000 16159
2004-12-24
2004-12-24
590
Peter V.