Philips 3000 V2 - Page 16

PHILIPS 3000 V2 01 INTRODUCTION
12/13
Problem Cause Solution
The coee is not hot
enough.
The cups you use are cold.
Preheat the cups by rinsing them with
hot water.
You added milk.
Whether the milk you add is warm or
cold, it will always decrease the tem-
perature of the coee to some extent.
The machine grinds the cof-
fee beans, but coee does
not come out.
The grind is set too ne. Adjust the grinder to a coarser setting.
The brew group is dirty. Clean the brew group.
The coee dispensing
spout is dirty.
Clean the coee dispensing spout and
its holes with a pipe cleaner.
The coee exit duct is
blocked.
Clean the coee exit duct with the
handle of the multifunctional tool or a
spoon handle.
The coee comes out slow-
ly.
The grind is ground too
nely.
Change the grinder to a coarser set-
ting.
The brew group is dirty. Clean the brew group.
The coee exit duct is
blocked.
Clean the coee exit duct with the
handle of the multifunctional tool or a
spoon handle.
The machine circuit is
blocked by limescale.
Descale the machine.
The milk does not froth.
The automatic milk frother
is dirty or not assembled
or installed correctly.
Clean the automatic milk frother and
make sure it is correctly assembled or
installed.
The type of milk used is
not suitable for frothing.
Dierent types of milk result in dif-
ferent amounts of froth and dierent
froth qualities. Semi-skimmed or full-
fat cow’s milk give good results.
The lter does not t.
You need to remove air
from the lter.
Let air bubbles come out of the lter.
There is still water in the
water tank.
Empty the water tank before you in-
stall the lter.
The coee grounds con-
tainer light lights up too
early.
Coee grounds contain-
er as been emptied with
while the machine was
switched o and the coun-
ter did not reset.
Empty the coee grounds container
with the machine switched on.