Philips DVR2008 - Software Upgrades and Hard Disk Management

52 EN
Upgrade software
The software installed in your recorder is
continuously being refi ned for greater stability
and compatibility of the set. Periodically,
Philips issues upgrades for the software which
you can copy onto a USB fl ash drive to install
on your recorder.
Caution!
Power supply must not be interrupted during
upgrade!
•
Copy upgrade information
Note
When checking for the latest fi rmare upgrade,
please also check for any accompanying
instructions on installing the fi rmware.
•
1 Insert the USB device to the USB socket.
Select [ Confi rm ] and press OK.
2 Press 主选单.
3 Press [ Settings ], then press OK.
4 Press X to select [ System ].
5 Press T to select [ Firmware
Upgrade ], then press OK.
A confi rmation message is displayed.
6 To proceed, select [ OK ], then press OK.
The information is copied to the USB
device.
7 Once copying completes, press OK and
remove the USB device.
8 Connect the USB device to a personal
computer with internet access.
Double-click on the fi le
<Philips_DVR2008.html> to be
directed to a web page to download
the latest fi rmware.



9 Follow the on-screen instructions and
download the required fi rmware.
Install fi rmware
Before you start...
Copy the latest fi rmware to the root
directory of your USB device.
Switch off the power supply to the
recorder.
1 Insert the USB device to the USB socket.
2 Press and hold 2 on the front panel and
switch on the recorder.
Release the 2 button when you see
the fi rmware install screen is displayed.
To retain the recordings and media fi les in
your hard disk,
1 Select [ Cancel ], then press OK.
Installation begins. Once complete,
the initial setup is displayed. (See
chapter “Get Started - First time
settings”).
To format your hard disk,
1 Select [ Confi rm ], then press OK.
2 You can modify the hard disk partition
between [ Media Files ] and
[ Recordings ].
Use WX keys to modify the hard disk
partition.
3 To confi rm, press OK.
Installation begins. Once complete,
the initial setup is displayed. (See
chapter “Get Started - First time
settings”.)
•
•


•

1_DVR2008-93_eng_wk822.indd 521_DVR2008-93_eng_wk822.indd 52 2008-05-26 10:53:21 AM2008-05-26 10:53:21 AM