Troubleshooting
Problem Cause Solution
I have diculties opening the lid after
cooking
Need to release the pressure
Set the pressure control valve to ‘Vent.’
Wait until the oater has dropped.
Floater stuck in up position
Set the pressure control valve to ‘Vent.’
Wait until the oater has dropped.
I have diculties closing the top lid
The sealing ring is not well assembled
Make sure the sealing ring is well assembled
around the inner lid.
Floater stuck in up position
The oater blocks the locking pin. Push
down the oater so that it does not block
the locking pin.
Leaking from under lid
Sealing ring missing
Put sealing ring in place correctly on inner lid.
Food debris under sealing ring Remove sealing ring, clean and replace.
Lid not correctly closed
Open and reclose lid, checking for correct
closing.
Leaking from oater
Sealing ring broken Replace sealing ring.
Food or debris under sealing ring Remove sealing ring, clean and replace.
Not pressurising / oater does not
rise up after the appliance starts
pressurising
Food & water are below minimum level
Add food/water. Make sure there is enough
food and water in the inner pot.
Leaking from lid or pressure control valve
Verify if sealing ring and inner lid are
inserted correctly.
Verify oating valve is present.
Verify there is not food stuck inside the
control valve.
E3 is displayed on the screen
The temperature inside the inner
pot is too high
Wait until it falls down to room temperature.
E1, E2 or E4 is displayed on the screen The All-In-One cooker has malfunctioned
Take the appliance to Philips service centre.
Philips All-in-One Cooker Recipe Book
To Next Page
Loading...
