Philips User manual - Set Timer Function

15
EN
English
To deactivate the timer function, press the
TIMER button repeatedly until the TIMER light
(
, , or ) is out.
Set the humidity level
Note
• Make sure that the water bucket is lled with
water when you want to use the humidication
function (see the chapter ‘Get started’, section
‘Prepare for humidication’).
You can set the desired humidity level only in
AUTO mode. When the humidity of the room
reaches the desired level, the humidity stays at
this level constantly.
• Press the HUMIDITY SET button once or
more times to set the desired air humidity
to 40%, 50% or 60%.
» The corresponding HUMIDITY SET
light (40%, 50% or 60%) goes on.
To change to another fan speed, press the
SPEED button.
Set the timer
With the timer function, you can let the
appliance operate for a set number of hours.
When the set time has elapsed, the appliance
automatically switches off.
You can use the timer function in the following
situations:
Situations You will see
Choose a fan
speed manually
(see ‘Manual’).
One of the SPEED lights (
,
or BOOST POWER) and
one of the TIMER lights (
, ,
or
) are on.
The appliance
is in auto mode
(see ‘Auto’).
The AUTO light is on.
One of the SPEED lights
(SILENT,
, or BOOST
POWER), and one of the
TIMER lights (
, , or ) are
on.
The appliance is
in silent mode
(see ‘Silent
mode’).
The SILENT light and one of
the TIMER lights (
, , or )
are on.
1 Press the TIMER button to activate the
timer.
» The TIMER light (
, , or ) goes on.
2 Press the TIMER button repeatedly to
choose the number of hours you want the
appliance to operate. The corresponding
TIMER light goes on.