Philips User manual - Replacing Filters; Replace Multi-care Filter

25EN
English
Note
• Insert the lters in the correct position.
• Make sure that you place the lters in the order
of HEPA lter, activated carbon lter, Multi-care
lter, and nally the pre-lter.
• Make sure that the side with the tag is pointing
towards you.
1 Switch off the appliance and unplug it.
2 Place your ngers in the recesses of the
side panels.
3 Gently pull the bottom of the panel out
(1), then lift the top part of the front panel
towards you (2).
4
2
1
4 Remove the pre-lter from the appliance.
4
1
2
7 Replacing the
filters
The lter lights ( / / / ) indicate
which lter has to be replaced.
Note
• If you remove the front panel for lter changing
while the appliance is switched on, all lights on
the control panel are off and the appliance stops
operating.
• Once the front panel is placed back to the
appliance, all lights ash twice. Then, the
appliance returns to its operating state.
Replace the Multi-care lter
Note
• The Multi-care lter is not washable nor vacuum
cleanable.
Replace the Multi-care lter when the lter light
ashes.
Tip
•
When you remove or insert lters, place the
appliance against a wall for more stability.