Philips User manual - Getting Started; Install Filters

8
EN
3 Remove all the lters from the appliance.
4 Remove all packaging material from the
lters.
5 Put the lters back into the appliance.
4
3
3 Getting started
Install lters
The appliance comes with all lters tted inside.
Remove the packaging of the lters before you
can use the appliance. Remove all lters, unpack
them, and place them back into the appliance
described as follows:
Tip
•
When you remove or insert lters, place the
appliance against a wall for more stability.
Note
• Insert the lters in the correct position.
• Make sure that you place the lters in the order
of HEPA lter, activated carbon lter, Multi-care
lter, and nally the pre-lter.
• Make sure that the side with the tag is pointing
towards you.
1 Place your ngers in the recesses of the
side panels.
2 Gently pull the bottom part of the front
panel out (1), then lift the top part of the
front panel towards you (2).
4
2
1