Philips User manual - Page 21

21EN
English
8 Put the pre-lter back into the appliance.
Attach all hooks properly to the appliance.
4
1
2
9 To reattach the front panel, insert the top
hooks into the top of the air appliance rst
(1). Then, push the panel against the body
of the appliance (2).
4
2
1
Note
• Alternatively, you can clean the pre-lter by
removing the dust with a vacuum cleaner.
• Make sure that the pre-lter is completely dry.
If it is still wet, bacteria may multiply in it and
shorten the lifetime of the pre-lter.
• Make sure that the side with two clips is pointing
towards you, and that all hooks of the pre-lter
are properly attached to the appliance.
3 To remove the pre-lter, press the two
clips down (1) and pull the lter towards
you (2).
4
1
2
4 Remove the Multi-care lter from the pre-
lter.
5 Wash the pre-lter under a running tap. If
the pre-lter is very dirty, use a soft brush
to brush away the dust.
6 Air dry the pre-lter.
7 Slide the Multi-care lter into the pre-lter.