Philips User manual - Page 28

28
EN
9 Place the pre-lter in the appliance.
4
1
2
Note
• Make sure that the side with two clips is pointing
towards you, and that all hooks of the pre-lter
are properly attached to the appliance.
10 To reattach the front panel, mount the
panel onto the top of the appliance rst
(1). Then, gently place the panel against the
body of the appliance (2).
4
2
1
11 Reset the activated carbon lter and the
HEPA lter lifetime (see the chapter ‘Reset
the lter lifetime counter’).
Note
• Do not touch the pleated lter surface, or smell
the lter as it has collected pollutants from the
air.
• Wash your hands after disposing of the used
lters.
6 Remove all packaging material from the
new lters.
7 Place the new HEPA lter in the appliance
rst.
4
8 Then, place the new activated carbon lter
in the appliance.
4
3