Philips VL440 - Page 103

TROUBLESHOOTING AND MAINTENANCE
A
02.9687.0001 C 31 October 2013 85
Step 4. Grasp filter with fingers and gently pull filter assembly straight up and out of fixed color
wheel. Note orientation of fixed color filter. New color filter must go in exactly the same.
Figure A-5: Removing / Installing Fixed Color Filters
Step 5. At position where fixed color filter was removed, place replacement fixed color filter over
open slot (as shown in Figure A-6), slide into wheel, and gently snap filter into place.
Figure A-6: Fixed Color Filter Wheel - Filter Installation.
Step 6. After filter is installed, reinstall rear head cover.
Fixed Color Filter Assembly
Fixed Color Filter Orientation
Rear of filter. This side
(reflective side) towards
lamp. Note position of light
shield.
Light Shield
Front of filter. This side
(non-reflective side)
towards front of luminaire.
Note positions of light
shield and dimple in tab.
Light Shield
Mounting Tab
(dimple on front
side)
Pull filter
straight up
and away
from wheel
assembly
Mounting Tab
(dimple on front side)
Open Position
(no filter)
Note:
Assembly shown for clarity.
Fixed Color Filter
Light Shield
Front of Assembly Shown
(side towards front lens)