INSTALLATION : INSTALLATION PROCEDURES
2
02.9687.0001 C 31 October 2013 21
Hanging the Luminaire
The VL440 / VL770 / VL880 Luminaire can be hung horizontally or vertically from any structure
designed to work with the type of load created by this moving luminaire. Two mounting truss hooks or
other mounting hardware are required. Many compatible truss hooks are available from different
manufacturers for your particular needs.
A minimum of two hooks per luminaire is required. If mounting method does not use truss hooks, two
attachment points, per luminaire, are required.
Install mounting hardware and brackets:
Step 1. Install truss hooks on two provided truss hook brackets as required.
Figure 2-6: Installing Truss Hooks
Note: Various types of truss hooks can be used. The Mega Claw truss hook (as shown in the example
above) as well as many other standard hooks, can be ordered separately.
Step 2. Determine required configuration of bracket installation. Brackets may be installed in either
orientation as shown.
Figure 2-7: Bracket Orientation Options
Step 3. While pulling up on locking mechanism release, fit keyed holes onto raised mounting
buttons at bottom of enclosure. Slide forward and release locking mechanism to lock in
place. Ensure brackets are locked securely. (Always face brackets in same direction as
shown.)
Bracket
Example Truss
Hook Installation
Mega Claw Truss Hook
(not provided)
Truss Hook Hardware
(not provided)
Brackets
Brackets
To Next Page
Loading...
