Phonic IS16v1 - Page 16

12
IS16
English
1.2.1 Channel Send Rotary Controls
Each of these level controls will determine the level of signal from
the corresponding input channel that will be sent to the currently
selectedAUXmix.
1.2.2 Channel Send Selects
These buttons will allow users to select which channels will be
sent to the currently selected group mix.
1.2.3 Channel Send Level Meters
These level meters will display the level of the corresponding input
channelthatissenttothecurrentlyselectedAUXorGroupsubmix.
1.2.4 Channel Send Meter Pre/Post Button
This button adjusts theAUX and group send meters between
pre-fader and post-fader meters.
1.2.5 On/Off Button
This button is used to activate and deactivate the currently selected
AUXorGroupmix.
1.2.6 Solo Button
PushingtheSolobuttonwillsendthecurrentlyselectedAUXor
Group mix to the Control Room mix. If the selected mix is set to
’solosafe’,thewordsSAFE|SOLOwillappearbelowthechannel
select option.
1.2.7 AUX/Group Mix Select
This button and the subsequent menu will allow users to select which
oftheAUXorGroupmixestheywishtoadjustthepropertiesof.
1.2.8 Pan Control
This control will adjust the left and right balance of the Group
mixthatsenttotheMainmix,MultimixesandControlRoommix
(whensoloedasanAFL).WhenthecorrespondingGroupmixis
assignedtoaMultioutput,thepanningisveryimportant.Signals
pannedleftcanonlybesenttoMulti1,3,5and7,whilethose
pannedrightcanonlybesenttoMulti2,4,6and8.
1.2.9 EFX Assign Buttons (not pictured)
Push either of these buttons to assign the output from the
correspondingEFXprocessorto the currentlyselectedAUXor
Groupmix.TheEFX1 and/or EFX2buttons will onlyappearin
the corresponding view page when the corresponding aux or
groupmixisselectedasthesourcesignalfortheEFXprocessor.
1.2.10 To Main Button
Pushing this button will send the currently selected Group mix to
the Main stereo mix.
1.2.11 Fader
Thisfaderwilladjustthenaloutputlevelofthecurrentlyselected
AUXorGroupmix.Usersarealsoabletousethehardwarefaders,
providedtheMasterselectionischosenontheLayerselection
sectionoftheIS16.Notethatfaderscannotbeadjustedonscreen,
insteadtheymustbeselectedandtherotarycontrolusedtoadjust
their levels. This helps avoid any level setting mishaps.
1.2.12 Level Meter
ThismeterwilldisplaythelevelofthecurrentlyselectedAUXor
Groupmix.Theleveldisplayedwillbeeitherpre-orpost-fader,
depending on the status of the Pre/Post Button.
1.2.13 Meter Pre/Post Button
Use this button to select whether the level meter displays the
pre-faderorpost-fadersignal.Whendark,thepost-fadersignal
will be displayed. When users push this button and it becomes
highlighted,thepre-fadersignalwillappear.