in-depth explanations refer to the Yocto Reference Manual.
In this part you will learn how to use the Yocto Project and the PHYTEC BSP.
5.1 Add new packages to the Root Filesystem
You can find the pre-build BSP in the virtual machine under /opt/PHYTEC_BSPs/phyFLEX-
i.MX6/. All necessary tools and programs are already pre-installed to directly start with
Yocto.Open a new terminal if you have not already done and change to the directory of the
pre-installed BSP:
Click the terminal icon on your desktop.
Type the following command to change to the BSP-directory:
cd/opt/PHYTEC_BSPs/phyFLEX‐i.MX6/
This directory is the start point for our BSP. You will also find further documents in this
directory. First we must set the correct environment.
Enter the following command
sourcesources/poky/oe‐init‐build‐env
PHYTEC Messtechnik GmbH 2015 L-781e_7 55
To Next Page
Loading...
