- Detach the inlet and outlet carburettor fuel lines
and the cooling circuit hoses (head outlet and ther-
mostat inlet).
- Detach the spark plug H.T. cable.
- Detach the generator wiring from the vehicle's
electrical circuit.
- Remove the swing-arm from the engine pivoting.
- The engine may now be removed.
WARNING
CARRY OUT THESE OPERATIONS WHEN THE ENGINE IS
COLD
WARNING
BE VERY CAREFUL WHEN HANDLING FUEL.
CAUTION
WHEN INSTALLING THE BATTERY, ATTACH THE POSI-
TIVE LEAD FIRST AND THEN THE NEGATIVE LEAD.
- When refitting the engine on the scooter, carry out the removal operations but in reverse order and
respect the locking torques indicated in the Characteristics Chapter.
-Check the engine oil level and if necessary top it up with the recommended type.
- Top-up the cooling circuit.
- Check the functioning of the accelerator and the electrical devices.
CAUTION
PAY PARTICULAR ATTENTION TO POSITIONING THE THROTTLE CONTROL TRANSMISSION
PROPERLY. CHECK THAT THERE IS A SMALL CLEARANCE WHEN THE VALVE IS IN ABUT-
MENT AGAINST THE SET SCREW.
See also
Seat
Side fairings
Footrest
Exhaust assy. Removal
Removal
Removing the rear wheel
Swing-arm
B 125-250 Engine from vehicle
ENG VE - 101
To Next Page
Loading...
