- Oil the free wheel "rollers".
Refitting the flywheel magneto
- Remove the freewheel retaining plate indicated
in the photograph
- Remove the transmission gear and the freewheel
- Insert the free wheel on the flywheel as shown in
the photo
- Then refit the flywheel with free wheel and trans-
mission gear
- Using the special flywheel stop tool, tighten up
the flywheel fixing nut to the prescribed torque
-Refit the retention plate
Specific tooling
020627Y Flywheel lock wrench
Locking torques (N*m)
Flywheel nut 94 ÷ 102
B 125-250 Engine
ENG - 137
To Next Page