Before you reassemble, wash all the components
and continue with the following checks.
Flywheel cover: Check that there are no cracks or
oxidation on the seat of the ceramic seal. Check
the capacity loads of the bearings and of the seal
ring. Check the efficiency of the drain hole.
Shaft: Check to be sure there is no oxidation.
Check that the impeller is in perfect condition.
Ceramic seal: Check that the ceramic seals are not
worn, cracked or scored. Check that the two rub-
ber seals are in perfect condition. Check the thrust
spring.
Bearings: Check that they do not have irregular
plays or are noisy.
Cooling system B 125-250
COOL SYS - 262
To Next Page
Loading...
