Pilz PNOZ mm0p - Technical Details; Technical details

8.1 Technical details
8 Technical Details
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: pilz.gmbh@pilz.de
8-2
Inputs
Voltage on the input circuit 24.0 V
Current on the input circuit 5 mA
Signal level at "0" -3 ... +5 V DC
Signal level at "1" 15 ... 30 V DC
Max. filter time 4.0 ms
Min. pulse duration 16 ms
Pulse suppression 0.6 ms
Auxiliary outputs
Voltage 24.0 V
Current 75 mA
Power 1.8 W
Short circuit-proof yes
Residual current at "0" 0.5 mA
Voltage at “1” UB - 2 V bei 0.1 A
Environmental data
Ambient temperature 0 - 60 °C
Storage temperature -25 - 70 °C
Climatic suitability in accordance with EN 60068-2-30,
EN 60068-2-78
93 % r. h. at 40 °C
Condensation not permitted
EMC EN 61131-2
Vibration to EN 60068-2-6
Frequency 10 - 150 Hz
Max. acceleration 1g
Airgap creepage in accordance with EN 61131-2
Overvoltage category II
Pollution degree 2
Rated insulation voltage 30 V
Rated impulse withstand voltage 2.50 kV
Shock stress
EN 60068-2-27 15g
11 ms
EN 60068-2-29 25g
6 ms
Mechanical data
Protection type
Mounting (e.g. cabinet) IP54
Housing IP20
Terminals IP20
DIN rail
Top hat rail 35 x 7.5 EN 50022
Recess width 27 mm
Maximum cable runs
per input 1.0 km
Sum of individual cable runs at the test pulse output 2 km
Housing material
Housing PC
Front PC
Configurable inputs/outputs (inputs or auxiliary out-
puts)