OPERATING MANUAL PSEN op4F/H-A series
Normal
operating
mode
Blanking only
Blanking valid
(OSSD ON)
Blanking invalid
(OSSD OFF)
Blanking zones not observed.
Re-configure blanking (teach in
if BCM)
Tolerance BCM active
Check the actual resolution for
the light curtain and the intended
activation of the tolerance
function.
Normal
operating
mode
Muting only
Muting active
unintentionally and during
active muting, check the partial
Override active
Override status
Activate the override button to
bridge OSSDs to light
Override timing error
Check and repeat the override
activation sequence.
Check the override
Lamp error
Check the lamp connections
and check for any potential
defects on the lamp.
Error
information
OSSD error
If the problem should persist,
please contact Pilz customer
services.
Microprocessor error
If the problem should persist,
please contact Pilz customer
Lens error
Activate RESET.
If the problem should persist,
please contact Pilz customer
EDM error
Check the EDM feedback line
and the EDM configuration.
Restart error
/RESET/REALIGN.
Communication error
Check the cascading
connection and check that the
terminator cap is installed
BCM Configuration error
Perform basic configuration
again.
If the problem should persist,
please contact Pilz customer
services.
ACM Configuration error
Perform advanced configuration
again.
If the problem should persist,
please contact customer
Critical error
Switch light curtain on/off.
If the problem should persist,
please contact Pilz customer
A critical error cannot be eliminated via a RESET.
The light curtain must be switched on and off. If the error should persist, please contact Pilz
customer services.