Pilz PSEN sc B 5 Series - PSENscan Configurator Connection

Wiring
Operating Manual PSEN sc B 5 Series
1004508-EN-02
43
7.5 Connection to PSENscan Configurator
The configuration of the safety laser scanner PSEN sc B 5 Series is carried out in
PSENscan Configurator on a configuration PC.
Evaluation device
PSENscan Configurator
PSEN sc B 5.5
} Ensure that the software PSENscan Configurator is installed on the configuration PC.
} Ensure that the safety laser scanner is switched off when creating a connection to the
configuration PC.
Procedure:
1. Use a 4-pin cable (see
Order references [ 70]) to connect the configuration PC to
the safety laser scanner.
2. Switch the safety laser scanner on.