Pilz PSEN sc B 5 Series - PSENscan Configurator Software; Configurator Basics and Installation

PSENscan Configurator
Operating Manual PSEN sc B 5 Series
1004508-EN-02
44
8 PSENscan Configurator
8.1 Basics
The PSENscan Configurator is a graphic tool
} For configuration of the safety laser scanners of the PSEN sc B 5 Series,
} For incorporation of the safety laser scanner into the network,
} For monitoring the safety laser scanners in the network,
} For creating reports,
} For password administration of the safety laser scanner of the PSEN sc B 5 Series
8.2 Installation
8.2.1 System requirements
Operating system: 32 or 64-Bit version from Windows 7 or Win-
dows XP
Processor: Pentium 4, min. 2 GHz
RAM: Min. 1 GB
Available hard drive space: Approx. 70 MB
Graphics card: min. 1024 x 768 pixel resolution, 65536 col-
ours
Interfaces: A free 100Mbps Ethernet- interface for data
transfer to the safety laser scanner.
To display the documentation: Adobe Acrobat Reader, from Version 7.1.0
8.2.2 Install PSENscan Configurator
Procedure:
1. Switch on your computer and start up the operating system.
2. Download the software PSENscan Configurator from the download area on the Pilz
homepage.
The software PSENscan Configurator is in the download area on the Pilz homepage at
http://www.pilz.com/support/downloads/
3. Double-click on the downloaded file.
The software PSENscan Configurator is installed.
The installer will guide you through the installation.
INFORMATION
To ensure that PSENscan Configurator functions correctly, the files and dir-
ectories in the installation directory of PSENscan Configurator must not be
modified manually once installed (e.g. with the Windows Explorer or a text
editor).