Pilz PSEN sc B 5 Series - Network and Device Configuration

PSENscan Configurator
Operating Manual PSEN sc B 5 Series
1004508-EN-02
45
8.2.3 Ethernet Connections
8.2.3.1 Factory default settings for the IP addresses
The factory-set default of the IP address of the safety laser scanner: 192.168.0.10.
INFORMATION
Use the correct IP address
A second address has been set up for internal functions of the safety laser
scanner. This address always follows directly after the IP address, specified
in the network settings.
– Ensure that only on IP address is used when the following IP address
is not assigned.
8.2.3.2 Connect automatically
The PSENscan Configurator offers the option of automatically finding a device available in
the network.
1. Select Device -> Search device.
The network is searched for connected PSEN sc B 5 Series.
Connected PSEN sc B 5 Series are listed under Network environment.
2. Double-click the safety laser scanner from Network environment.
The safety laser scanner is displayed in the work window with IP address, firmware ver-
sion and status information.
3. Select Settings -> Change network settings.
Enter the password for the safety laser scanner (the ex-works setting for the password
is admin).
4. Enter the network data for connecting to the network and click OK.
5. The safety laser scanner switches to the OFF state. Click OK to continue.
6. The safety laser scanner is displayed automatically with an updated IP address.
7. Double-click on the device to create a new configuration.
8.3 Download configuration to device
You can use the Download configuration to device function to download the configura-
tion in the PSENscan Configurator to a connected device. Once the configuration test has
been completed, the new configuration in the connected device can be accepted or rejec-
ted.
Load configuration
1. Make sure that the Download configuration work window shows a report, listing the
differences between the existing configuration on the connected device and the config-
uration in the PSENscan Configurator.
The configuration on the connected device is labelled DEV.