Pilz PSEN sc B 5 Series - Page 58

Operation
Operating Manual PSEN sc B 5 Series
1004508-EN-02
58
Message
(shown in the display)
Error/cause Description/measure
INTF11
An error occurred during the system
test.
Perform a reset of the safety laser scan-
ner.
If the error persists, please contact Pilz.
INTF12
An error occurred during the system
test.
Perform a reset of the safety laser scan-
ner.
If the error persists, please contact Pilz.
INTF13
An error occurred during the system
test.
Perform a reset of the safety laser scan-
ner.
If the error persists, please contact Pilz.
INTF14
An error occurred during the system
test.
Perform a reset of the safety laser scan-
ner.
If the error persists, please contact Pilz.
INTF15
An error occurred during the system
test.
Perform a reset of the safety laser scan-
ner.
If the error persists, please contact Pilz.
INTF16
An error occurred during the system
test.
Perform a reset of the safety laser scan-
ner.
If the error persists, please contact Pilz.
INTF17
An error occurred during the system
test.
Perform a reset of the safety laser scan-
ner.
If the error persists, please contact Pilz.
INTF18
An error occurred during the system
test.
Perform a reset of the safety laser scan-
ner.
If the error persists, please contact Pilz.
INTF20
An error occurred during the system
test.
Perform a reset of the safety laser scan-
ner.
If the error persists, please contact Pilz.
MEMF
An error has occurred in the memory
module.
Check that the memory module is firmly
seated and perform a reset of the safety
laser scanner.
If the error persists, please contact Pilz.
OSSD1F3
Earth fault has occurred ad OSSD1. Check the state and the wiring of the
OSSD.
If the error persists, please contact Pilz.
OSSDF1
An error has occurred when testing
the OSSD1.
Check the state and the wiring of the
OSSD.
If the error persists, please contact Pilz.