Pilz PSS 3075-3 Series - Page 12

Overview
2-2 Operating Manual: PSS 3075-3 Series
For non-safety-related applications, the PSS can be connected to various
standard bus systems (e.g. PROFIBUS-DP). The bus interfaces that are
available will depend on the unit type.
INFORMATION
• The standard bus interfaces are described in separate operating
manuals. The necessary operating manuals are supplied with the rele-
vant unit types.
• Drivers (standard function blocks) from the corresponding Pilz software
package will be required in order to connect to the various standard bus
systems.
Example:
PSS SB 3075-3 ETH-2
Safety systems PSS 3075-3 with SafetyBUS p- and Ethernet interface.
The digital inputs can be used for local emergency stop monitoring, for
example. They are suitable for connecting single or dual-channel input
devices, with or without test pulses. The test pulse outputs are suitable for
testing input devices.
The single or dual-pole outputs can be used to drive valves, for example.
SafetyBUS p enables you to establish a safe decentralised network of
several programmable safety systems and/or to connect decentralised
modules. The PSS can perform the function of a Management, Logic or
Input/Output Device on SafetyBUS p.