PDP-6071PU
162
1234
1234
C
D
F
A
B
E
8.2.4.3 SG PATTERN
1 COLOR BAR1 Colorbar (75%)
2 COLOR BAR2 Colorbar (100%)
3 RAMP1 Ramp (100% white)
4 RAMP2 Ramp (100% Yellow)
5 RAMP3 Ramp (75% Green)
6 RAMP4 Ramp (75% Red)
7 RAMP5 Ramp (75% Blue)
8 RASTER1 Raster (100% White)
9 RASTER2 Raster (75% Yellow)
10 RASTER3 Raster (75% Cyanide)
11 RASTER4 Raster (75% Green)
12 RASTER5 Raster (75% Magenta)
13 RASTER6 Raster (75% Red)
14 RASTER7 Raster (75% Blue)
15 RASTER8 Raster (-% Black)
16 10STEP1 10STEP (100% white)
17 10STEP2 10STEP (100% Yellow)
18 10STEP3 10STEP (75% Green)
19 10STEP4 10STEP (75% Red)
20 10STEP5 10STEP (75% Blue)
Notes when using SG MODE/SG PATTERN
• During factory mode, choose the correct route when changing.
• Basically, during VDEC SG output, make sure to connect SG output’s Y or G to the
AVI input terminal of VDEC.
• During SG MODE, turn off the blanking 50IRE setup function.
• During VDEC SG output, set the YC seperation setting to NTSC.
• It is possible to use ANALOG OUT MODE together during DIGITAL OUT MODE.
The Main VDEC can output digital color difference, in which colors will appear. But the route
to VDEC input cannot be analysed therefore care should be taken when using.
Depending on the situation, please use the proper analog/digital output.
• The SG MODE outputs color difference and RGB only. Therefore, in the case of CVBS, only
the Y input is used resulting in no color. This is not a damage result nor error.
• The SG MODE’s ANA AD RGB (route to input 525i to AD by RGB) as a set’s route, the setting
does not exist. For this account the latter part from MVDEC does not have set values, resulting
in having funny colors in colorbar, the brightness changes after switching, etc.
This is not a damage result nor error.
• Depending on MVDEC’s part version, ANA_MVDEC_YCBCR may not display colors.
No. Function/Display SG Pattern(Brightness IRE Level/Color)
To Next Page
Loading...
Need help?
General