Pioneer PDP-60MXE20 User Manual

144
Integrator Mode
14) Cooling Fan Control Setting
A cooling fan is located on the rear surface of the display.
This function switches the method for controlling this fan.
For automatic control according to an internal temperature sensor, Set to ‘AUTO’.
For maximum rpm (AUTO CONTROL: OFF): Set to ‘MAX’.
Note
The ‘MAX’ setting is effective for special installations.
However, since the fan rotation noise increases, the effect on the surrounding area should be taken into consideration.
For details, refer to section 3, “Installation Site Requirements” (pg. 16).
Factory setting: AUTO
1 Enter the integrator mode.
(Refer to section 5.4.1, “About the Integrator Mode” (pg. 123).)
2 Select ‘OPTION’.
3 Place the cursor on ‘FAN CONTROL’ then press the [SET]
button to change the setting.
Each time the [SET] button is pressed, the setting changes
as shown below.
The ‘FAN CONTROL’ setting is common for all inputs.
Screen 3
INTEGRATOR INPUT1
CHANGE
SCREEN SETUP OPTION
F AN CONTROL
OSD
F RONT I ND I CATOR
COLOR MODE
PRO USE
FRC
PICTURE
:
:
:
:
SET EXIT MENU
AUTO
NORMAL
ON
ON
3
AUTO
MAX
3

Pioneer PDP-60MXE20 Specifications

General

Depth	122 mm
Width	1470 mm
Height	880 mm
Weight	62000 g
Pixel pitch	0.966 x 0.966 mm
Product color	Black
Audio (L/R) out	1
Noise reduction	Yes
Display diagonal	60 \
Display brightness	1000 cd/m²
Display resolution	1365 x 768 pixels
Display technology	Plasma
Power requirements	AC 100 - 240 V, 50/60 Hz
Viewing angle, horizontal	160 °
Display viewable area (HxV)	1318.6 x 741.9 mm
Operating temperature (T-T)	0 - 40 °C
Power consumption (standby)	0.8 W
Power consumption (typical)	450 W
Operating relative humidity (H-H)	20 - 80 %