27
3.4.2 Hanging on the wall
Carefully read the following imformation before attempting to hang the unit on a wall. Take note of the various limitations
specified in this section. Mount the unit so that twisting, bending, or any other warping does not exceed 4 mm.
Shaded areas indicate attachment points for mounting hardware.
Special Instruction (Hanging on the wall)
Operating temperature restrictions
✩ Standard single-unit installation
Distance from wall (A) BC DAmbient temperature
50 mm or less 300 mm or more 300 mm or more 300 mm or more 0 °C to 35 °C
50 mm or more 100 mm or more 50 mm or more 50 mm or more 0 °C to 40 °C
✩ Requirements when used with PDP-S55-LR speaker system
When installed as a single unit, all requirements are the same as those listed above for horizontal/
vertical, left/right reverse installations. However, the figures listed above indicate the distance
between the speakers and the wall.
25
162
880
A
B
C
D
D
1470
50
Note
Different temperature restrictions apply to the PDK-WM03. Refer to “4.5 Wall Mount Unit PDK-WM03” (pg. 70). For a
wall-mount installation, allow adequate space (a clearance of 300 mm or more) above, below, and to each side of the
panel.
: Thermometer (temperature measurement point)
To Next Page
Loading...
