Pioneer PDP-60MXE20 - Page 153

153
Integrator Mode
3
3
0 to 42
LAST
2
2
7 Setting when MULTI is selected
Place the cursor on ‘MULTI MODE’ then use the [2/3] buttons to change the settings.
Each time a [2/3] button is pressed, the setting changes as shown below.
Change the setting by placing the cursor on LEFT (or MAIN) in INPUT MODE, then pressing the [2/3] buttons.
The signal that has been selected is displayed in the left screen of SIDE BY SIDE 1 to 3 (or in the main screen of
Picture-in-picture).
Each time a [2/3] button is pressed, the setting changes as shown below.
For PC signal input
For video signal input
Change the setting by placing the cursor on RIGHT (or SUB) in INPUT MODE, then pressing the [2/3] buttons.
The signal that has been selected is displayed in the right screen of SIDE BY SIDE 1 to 3 (or in the sub screen of
Picture-in-picture).
Each time a [2/3] button is pressed, the setting changes as shown below.
For PC signal input
For video signal input
5 Place the cursor on ‘VOLUME’ then use the [2/3] buttons
to change the settings.
Each time a [2/3] button is pressed, the setting changes
as shown below.
SIDE BY SIDE1
3
33
222
SIDE BY SIDE2 SIDE BY SIDE3
BOTTOM LEFT
22 2 2
33 3
3
BOTTOM RIGHTTOP RIGHT
TOP LEFT
INPUT1
222
33 3
INPUT2 INPUT3
INPUT5
33
22
INPUT4
INPUT1
2
3
INPUT2
3
2
INPUT1
2
3
INPUT2
3
2
INPUT1
222
33 3
INPUT2 INPUT3
INPUT5
33
22
INPUT4
Screen 5
0
INPUT
INPUT1
VOLUME
RE T U RN
:
:
:
SET EXITMENU
PWR. ON MODE