81
FX-MG8156ZT,MG8156ZT-91,MG8317ZT,MG8317ZT-91
- Error No. Display
The error mode is turned on if a CD player becomes not playable or is forced to halt due to an error. Cause(s) of an
error will be indicated with numerical characters. The error-number-display function is intended to facilitate the
error analysis and resulting repair work.
(1) Error Code
Error code Category Troubles Description/Cause(s)
10 Electricity Carriage home error Unable to move to or from inner perimeter
→
Failure on home switch or carriage move trouble.
11 Electricity Focus search error Unable to set a focus
→
Scratches or stains on backside of the disc, severe vibrations,
CD-R is not written to the disc
(it can happen on the backside of the disc).
12 Electricity Spindle lock error Spindle lock unavailable, sub-code unreadable
Sub-code error
→
Failure on spindle, scratches on the disc, stains or strong
vibrations.
14 Electricity Mirror error MIRR signal error continues for 500 msec or more
→
Stains on the disc or strong vibrations.
17 Electricity Setup error AGC protection cannot be turned on in time or focus can be easily lost
→
Scratches or stains on the disc or strong vibrations.
19 Electricity Tracking Balance error Tracking error level is low or tracking balance adjustment is unavailable
→
Failure on the pickup or tracking-error circuit.
30 Electricity Search time-out Target address can't be reached
→
Failure on the carriage/tracking or scratches on the disc.
A0 System Error on power supply Ground fault of power supply (VD)
→
Failure on switching transistor or failure of power supply.
Error code AVC-LAN Error code
11, 12, 14, 17, 19, 30 ERROR1
10 ERROR3
A0 ERROR4
To Next Page
Loading...
