Piper PA-28RT-201T - Page 100

—CAUTION—
Do not lubricate control wheel shaft or bushing. Clean only
using alcohol or other suitable solvent.
COMPONENT LUBRICANT FREQUENCY
1. AILERON HINGE PINS MIL-L-7870 100 HRS
2. FLAP HINGE BEARINGS MIL-L-7870 100 HRS
3. STABILATOR HINGE PINS MIL-L-7870 100 HRS
4. RUDDER HINGE BEARINGS MIL-L-7870 100 HRS
5. CONTROL CABLE PULLEYS MIL-L-7870 100 HRS
6. TRIM CONTROL WHEEL MIL-L-7870 100 HRS
7. O-RING, CONTROL SHAFT BUSHING PARKER O-RING*
LUBRICANT AS REQUIRED
8. TEE BAR PIVOT POINT MIL-L-7870 100 HRS
9. CONTROL COLUMN CHAIN MIL-L-7870 500 HRS
10. CONTROL COLUMN FLEX. JOINTS AND SPROCKET MIL-L-7870 100 HRS
11. STABILATOR CONTROL MIL-L-7870 100 HRS
*SPECIAL INSTRUCTIONS
Disassemble O-ring retainer plates from instrument panel; lubricate O-ring and reassemble.
Figure 12-6. Lubrication Chart (Control System)
12-20-32
Page 12-21
Interim Revision: July 30, 1986
1E4
PIPER AIRCRAFT
PA-28RT-201 / 201T
*MAINTENANCE MANUAL