Pitco E7 User Manual

To set the melt cycle option press the pH key and use the
key to toggle between the three options
available. Solid shortening melt cycle (MELT S), Liquid shortening melt cycle (MELT L) or no melt
cycle (NO MELT). It is highly recommended that a melt cycle is used to ensure longevity of oil and
fryer.
To view the recovery test data
data. Each time the fryer heats through the temperature range of250°F - 300°F it records (in seconds)
the time it took and stores it as recovery data. This data can be recorded when the fryer is new and
viewed again at a later date to see wether the fryer is performing correctly.
To set the control mode press the — key and use the — key to toggle between the options. The
computer may be set in a "CONTROL" mode for total computer control or in "TIMER" mode where
the Auxiliary Thermostat will control the temperature of the oil and the computer will act as a timer.
To exit the level 2 programming mode at any time press the jjpj key two times. This will return you
to the normal cook mode.
2.5 The Digital Control
The Pitco Digital Controller has been designed to take the place of the standard Solid State
Thermostat. It provides the operator with more functions than the Solid State without giving the
operator all of the features of an Intellifry Cooking Computer.
2.5.1 Operating the Digital Controller
Below is listed the control functions of the Pitco Digital Controller:
Press the K?) key to turn the control ON. Press and hold the (J) key for 3 seconds to turn the
control OFF.
Press the
Press the
'o
. ^ J
or the
o'
^7
key to start the Left or Right timers.
key to display the ACTUAL Temperature. Press the ^ key a second time to
display the SET temperature.
2-8

Pitco E7 Specifications

General

Brand	Pitco
Model	E7
Category	Fryer
Language	English