Pitco E7 - Initial Adjustments and Checks; Performing Visual Checks

1.5 INITIAL ADJUSTMENTS
After your fryer has been installed as described in section 1.4, it needs to be checked and adjusted
to ensure that it will perform as designed.
1.5.1 Visual Checks
Before you begin filling and adjusting the fryer, perform the following visual checks:
a. After the fryer is in its permanent location, lock the rollers and check the levelness. Any
additional leveling that is necessary can be performed as described in section 1.3.
Heating Elements
Figure 1-2 Inside Fryer Tank
b. Check the temperature bulbs (thermostat/high-limit) and other fryer tank components to
ensure that the mounting screws are tight and all components are secure. Ensure that the
heating elements are down and in place. Figure 1-2 shows fryer tank components.
1-9