Pitney Bowes DA50S - Setting Factory Defaults (from LCD Menu

A-24 SV61831 Rev. A DA50S/DA55S/DA70S/DA75S AddressRight™ Printers Service Manual
Appendix A • Printer Control Panel Menus and Utilities
You can return all menu settings to their factory defaults by pressing and
holding On-Line while turning on the power to the printer. Several messages
display during this process:
Loading Settings. Please wait...
Displayed when printer is first turned on.
Reset memory to defaults? -No +YES
Displayed after printer start up. If Yes is selected, the printer settings
as reset to factory default. The ‘Resetting Printer’ message is displayed
while the printer is being reset. If No is selected, the printer settings are
not reset. The ‘Restarting Printer’ message is displayed.
Resetting printer. Please wait...
Displayed while the printer is being reset to factory defaults.
Memory reset. Restarting printer...
Displayed for three seconds when printer settings have been reset to fac-
tory defaults.
Restarting printer...
Displayed for three seconds when user chooses not to reset the printer to
factory defaults
A list of the factory default settings is shown below and on the next page.
Setting Default
MAIN MENU
Normal Mode Online at startup
Print Quality Executive (600 dpi)
Feed Delay (SH) 0
Font Courier New
Font Size 12
Bold Off
Italic Off
Barcode Location Off
Barcode (9 Digit On/Off) Off
Barcode Bar Width Normal
Setting Default
SERVICE MENU
Left Justify 4
Envelope Bottom Edge 16
A.6 Setting
Factory
Defaults (from
LCD Menu)