DA50S/DA55S/DA70S/DA75S AddressRight™ Printers Service Manual
A-17
Printer Control Panel Menus and Utilities • Appendix A
A.4 LCD Setup
Menu
13. Tray Break*
Submenu Option Settings What It Does
A. Enable/Disable Enabled,
Disabled
Allows you to enable or disable the detection
of printer tray breaks. The system will detect
these breaks based on strings of characters
found in the data stream.
B. Break Charac-
ter
! “ # $ % &
‘ ( ) * + , -
. / 0 through
9 : ; <
= > ? @ A
through Z
Allows you to specify the break characters
used to identify the tray break.
C. Break Charac-
ter Count
1 to 12 Allows you to specify the number of break
characters in the tray break.
D. Character Ori-
entation
Vertical or
Horizontal
Allows you to specify the alignment of the
break characters as either vertical or hori-
zontal.
E. Break Location Before Ad-
dress, After
Address
Allows you to specify whether to print the
break characters before or after the address.
F. Print Break
Characters
Enabled,
Disabled
Allows you to specify whether to print or not
print the break characters.
G. Break Pause
Time
0 to 30.00
seconds ( in
0.25 second
increments)
Allows you to specify the length of time the
printer will pause printing when a tray break
is detected.
14. Low Ink Warning
Submenu Option Settings What It Does
A. Display Warn-
ing
Enabled,
Disabled
Allows you to set whether the printer pro-
vides a low ink warning when the ink thresh-
old is reached.
B. Warning
Threshold
2 to 7 percent
(in 1 percent
increments)
Allows you to set the ink threshold (in
percentage of ink remaining) for the low ink
warning to display.
C. Stop When
Empty
Enabled,
Disabled
Allows the printer to stop when the ink has
been depleted (0 percent remaining).
*The Bundle Break
and Tray Break
features are not
functional at the time
of this writing but are
planned for a future
release.
To Next Page
Loading...
