Confirming Job Setup
Job setup is now complete. Using the inserter model and icons, the touchscreen display shows all of the
selected job settings.
1. Review the job settings.
2. Tap the << and >> buttons to scroll back and change a setting.
3. When the setup changes are complete, tap the Setup button to accept the new settings and exit
setup mode.
The touchscreen displays the new job settings with the message Trial Piece Required.
4. Test the setup by running a trial piece.
NOTE: The inserter retains job settings until they are changed or deleted, even when the power is
disconnected.
Product Overview
Pitney Bowes Relay™ 2500, 3500, 4500 User Guide December, 2018 Page 40 of 174
To Next Page
