Modifying an Existing Job
Modifying an existing job requires Supervisor level access.
1. Tap the Setup button on the main screen. The Enter Access Code: field displays over the
inserter model and the keypad appears on the touchscreen display.
2. Using the keypad, type the Supervisor code (71) and tap the Enter key. The Enter Access
Code: field counts up or down to display the password code entered.
3. Tap the >> button to accept the code and advance to the job selection.
4. Tap the + and – buttons to display the job you wish to modify.
5. Tap the >> button to accept the job selection and advance to the job programming settings.
6. Tap the << and >> button to scroll through the setting(s).
7. Tap the + and – buttons to scroll through the options or desired values.
8. Tap the >> button to accept the job setting.
9. Tap the Setup button to save the changes and exit setup mode.
Product Overview
Pitney Bowes Relay™ 2500, 3500, 4500 User Guide December, 2018 Page 65 of 174
To Next Page
Loading...
