Pixsys ATR 141 - Manual Start of Tuning; Autotuning Function

31
15 - MANUAL START OF TUNING
Select parameter as (manual start)
Press Display Do
1
Display shows
2
Display shows
3
or
wait for 4
seconds.
Display will show
process value and
alternately until
the function is
completed (it may take
a few minutes).
To interrupt the
function press
and
press
to select
.
16 - AUTOTUNING
Parameter must be selected as . Autotuning
starts automatically when the controller is switched-on or when
setpoint value has been modified. Display alternates between
process value and the writing
until the function has
been completed (it may take a few minutes).
To interrupt the function, press
and press to select
.