Pixsys ATR 142 User Manual

38 - ATR142 - User manual
9
o . c a L.
Offset Calibration
number added/subtracted to process value visualized
on display (usually correcting the ambient temperature
value).
-999…+1000 [digit
3
] for linear sensors and potentiome-
ters.
-99.9…+100.0 (degrees.tenths for temperature sensors).
> Default: 0.0.
10
G. ca L.
Gain Calibration
this % is multiplied with displayed value to calibrate the
process value. -99.9%…+10 0.0% > Default: 0.0
11
act. t.
Action type
regulation type
hea t
Heating (N.A.) > Default
co o L,
Cooling (N.C.)
H.o.o.s.
If process is above setpoint, output is disabled
(Heating).
12
c.re.
Command Reset
type of reset for state of command contact (always
automatic in PID functioning).
a.re.
Automatic Reset > Default
m.re.
Manual Reset
m.re.s.
Manual Reset Stored
13
c.s . e.
Command State Error
state of contact for command output in case of error.
c. o .
> Default
c. c.
14
c.Ld.
Command Led
state of OUT1 led corresponding to the relevant contact.
c. o .
c. c.
> Default

Pixsys ATR 142 Specifications

General

Brand	Pixsys
Model	ATR 142
Category	Controller
Language	English