Pixsys ATR 401 - Summary of Confi Guration Parameters

ATR401 - User manual 57
16 Summary of Con guration parameters
Date Model 401:
Installer System:
Notes:
1

Select type of command output
2

Analogue input 1 con guration
3
  
Select type of decimal visualized by sensor 1
4
 
AI1 range lower limit only for linear
5

AI1 range upper limit only for linear
6

AI1 O set calibration
7
 
AI1 Gain calibration
8
 
Limits automatic setting for linear inputs
9
  
AI1 setpoint lower limit
10

AI1 setpoint upper limit
11

Analogue input 2 con guration
12
  
Select type of decimal visualized by sensor 2
13
 
AI2 range lower limit only for linear
14

AI2 range upper limit only for linear
15

AI2 o set calibration
16
 
AI2 gain calibration
17
  
AI2 setpoint lower limit
18

AI2 setpoint upper limit
19
  
Select process value related to command output
20
 
Enable remote setpoint
21

Regulation type for command output
22

Hysteresis in ON / OFF or dead band in P.I.D.
23

Command contact reset type
24

Contact status for command output in case of
error
25
 
C1 led status in correspondence of relevant
contact