Pixsys ATR 401 - Alarm Intervention Modes

ATR401 - User manual 51
92  Baud Rate
Selects baudrate for serial communication
 4800 bit/s
 9600 bit/s
 19200 bit/s (Default)
 28800 bit/s
 39400 bit/s
 57600 bit/s
    115200 bit /s
93  Slave Address
Selects slave address for serial communication
1 – 254. Default: 254
94  Serial Delay
Selects serial delay
0 – 100 milliseconds. Default: 20
13 Alarm Intervention Modes
Absolute Alarm or Threshold Alarm (  selection)
Absolute alarm with controller in
heating functioning (par. 21 
selected ) and hysteresis value
greater than “0” (par. 40  > 0).
N.B.
15
Absolute alarm with controller in
heating functioning (par. 21  selected
) and hysteresis value less than
“0” (par. 40  < 0).
N.B.
15