Pixsys ATR 621 series User Manual

ATR 621 - User manual 17
Set the controller in  and follow the points below:
Press Display Do
1
PRG
M
Red display shows 
2
Decrease or increase to visuali-
ze  (for cycle no.1), 
(for cycle no.2) up to  (for
cycle no.15).
6.1.1 Programming of starting setpoint (if enabled)
This is useful for example when the kiln is still hot and cycle has to start from
a lower temperature.
Press Display Do
3
O
K
Red display shows .*
Green display shows “starting
setpoint”.
Otherwise pass to point 5.
At any time press
ST
A
R
T
STO
P
to exit
programming with storing
modi ed data.
4
Increase or decrease value on
green display.
Enter starting setpoint (starting
temperature)
6.1.2 Programming of the step
Press Display Do
5
O
K
Red display shows    .
Green display shows step time.
6
Increase or decrease value on
green display.
NB: Each cycle is composed of
max. 45 programmable steps,
after those it skips automati-
cally to point 12.
Enter step
duration in
hour:minutes.
NB: Set for endless time or --.--
for cycle end (if not all steps are
used) and skip to point 11.
*
The two  rst digits indicate the number of the step which is being modi ed. Last digit visualizes
 if a step duration time is being entered,  if a setpoint value is being entered (ex: temperature
to reach into selected time) and
 if the status of the auxiliary output is being entered.

Pixsys ATR 621 series Specifications

General

Brand	Pixsys
Model	ATR 621 series
Category	Controller
Language	English