Pixsys ATR 621 series - Summary of Confi Guration Parameters

48 ATR 621 - User manual
14 Summary of con guration parameters
Date: Model: ATR621-
Installer: Installation:
Notes:
1

Select type of command output
2

Analogue input AI1 con guration AI1
3

Select type of visualized decimal
4
  
AI1 range lower limit, only for linear
5

AI1 range upper limit, only for linear
6

AI1 o set calibration
7
 
AI1 gain calibration
8
 
Setpoint lower limit
9

Setpoint upper limit
10

Degrees type selection
11

Autotuning type selection
12

Deviation from command setpoint for manual
tune
13

Max. gap for automatic tune
14

Min. proportional band for automatic tune
15

Max. proportional band for automatic tune
16

Min. integral time for automatic tune
17

Reserved
18

Regulation type for command output
19

Hysteresis in ON / OFF or dead band in P.I.D.
20
  
Proportional band
21

Integral time
22

Derivative time
23

Cycle time
24
   
Min. value for command output percentage
25

Max. value for command output percentage
26
 
Status of command output contact in case of
error
27

Digital input functioning
28

Digital input contact
29
   
Red display in run visualization
30

Initial waiting
31

Cycle start setpoint