Pixsys DRR245 - Operating Mode and Digital Input

44 - DRR245 - User manual
59
op.mo.
Operating Mode
Select operating mode.
(Par. 8.7 pag. 18) (Par. 9.2 pag. 23)
co nt.
Controller (Default)
p r. cY.
Pre-programmed cycle
2t.s.
Setpoint change by digital input
2t. s .i .
Setpoint change by digital input with impulse command
3 t. s .i .
3 sets change by digital input with impulse command
4 t. s .i .
4 sets change by digital input with impulse command
t. res.
Reset time (custom function)
p.c.s.s.
Pre-programmed cycle with Start / Stop only by digital input
60
au.ma.
Automatic / Manual
Enable automatic / manual selection
(Par. 8.6 pag. 18)
di s .
Disabled (Default)
En.
Enabled
En .St.
Enabled with memory
61
d G t .i .
Digital Input
Digital input functioning (P59 selection must be
co nt.
or
Pr. cY.
) (Par. 9.2
pag. 23)
di s .
Disabled (Default)
st.st.
Start / Stop
rn.n.o.
Run N.O. (enables regulation with N.O. contact)
rn.n.c.
Run N.C. (enables regulation with N.C. contact)
L.c.n.o.
Lock conversion N.O. (stop conversion and display value with
N.O.)
L.c.n.c.
Lock conversion N.C. (stop conversion and display value with
N.C.)
tu n e
Manual Tune (by digital input)
a.ma.i.
Automatic / Manual Impulse (if enabled on parameter 60)
a.ma.c.
Automatic / Manual Contact (if enabled on parameter 60)