PLANET ECLIPSE GEO CS1 - Filter, Trigger, and Display Settings

FIG-1
FIG-3
FIG-2
FIG-4
27
GEO:CS1
ELECTRONICS
USER INTERFACE PARAMETERS
FIG-1 - FILTER MENU
The FILTER menu parameters tune the CS1 software lters which prevent the CS1 from ring unless all of
the necessary conditions are met. Factory default settings are suitable for most set-ups however, certain
loader and trigger set-ups may require more modication.
FIG-2 - DEBOUNCE PARAMETER
This sets the amount of trigger bounce that may be
present and can be set from level 1 to level 9.
> LEVEL1: Least ltering (most bounce).
> LEVEL9: Most ltering (least bounce).
> CANCEL: Editing is cancelled and unchanged.
FIG-3 - EMPTY PARAMETER
This sets the time delay between the breech sensor (BS) recognising the breech as EMPTY
(bolt retracted) and the next shot being allowed to re.
This can be set between 1.0 and 20.0 milliseconds in 0.1 millisecond increments.
FIG-4 - FULL PARAMETER
This sets the delay between the paintball landing in the breech and the marker being allowed to re.
This parameter can be set between 1.0 and 20.0 milliseconds in 0.1 millisecond increments.