FIG-1
46
GEO:CS1
TECHNICAL INFORMATION
SL5 INLINE REGULATOR
1,2
POPS screws
10-32 UNF x 1.25” cap head socket
POPS seal
Piston o-ring
14 x 2 NBR70
Regulator piston
Regulator spring
3
Adjuster top
Regulator body
Regulator seal
Purge poppet spring
4
POPS lter
Purge poppet
4
#015 NBR70 #016 NBR70
Internal
#008 NBR70
Adjuster bottom
Adjuster o-ring #011 NBR70
POPS assembly
1 Reset the SL5 regulator to factory after re-assembly.
2 Only use the SL5 regulator with the CS1.
3 Only use the CS1 SL5 spring with the SL5 inline regulator.
4 Failure to re-install the Purge poppet assembly correctly
could seriously damage the CS1.
To Next Page
Loading...
